I wonder if someone can assist with the solution I am looking to implement. We are having a new radio link which will connect one of our remote sites back to head office (Kensington). The radio links terminate at the remote end on a 1Gbps which is a WS-C2950G-24-EI. The Kensington also terminates on a 1Gbps port on a 6509 switch. Just want to check if the solution I have proposed is viable.
I have created a VLAN82 on the 6509 end and made the switch port Gi2/46 member of the VLAN. The remote end I am not too sure about. The corp1r001 fa0/0 connects to the corp1sw02 switch on fa0/1 and is on a flat VLAN1 users are also on VLAN1. Also on corp1r001 I have created a sub-interface on fa0/1 as fa0/1.82 and using encapsulation dot1q with the specified IP address. I have then connected that to fa0/24 on corp1sw02 and made that port a member of VLAN82. I have also made gi0/2 on corp1sw02 a member of VLAN82 also. Will this work or will there be issues because both the routers interfaces are connected to the same switch? Any feedback and suggestions are most appreciated.