IPM restore gets stuck at 40 % and 90%

Unanswered Question
May 15th, 2008

During a restore from 2.6 backup to a new clean 3.1 install, the process seems to halt at 40% it stayed like this for 8 hours so I had to stop with control c then it stuck again at 90% - in the end it still reported as successful

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
smahbub Thu, 05/22/2008 - 06:24

can you provide the exact error message taht you are getting ehile performing the restore which will help us better to find the cause of the issue and resolve the same.

MARVIN SPITERI Thu, 05/22/2008 - 22:22

Hi thanks for replying, the strange thing is that there were no error messages it just seemd to halt at 90% it stayed that way overnight 8hrs - then with cntl c it continued - no errors noticed in logs


This Discussion