05-16-2008 05:07 PM - edited 03-03-2019 09:59 PM
Hi Friend
I have One office & it is connected by two different ISP1 and ISP 2 ( Different AS number ), I have two 2 mb link between them. Now i want to configure traffic in such way one link use only 60 % with ISP1 and other link to IPS2 is using 40% traffic, How i can configure this ?
-V
05-16-2008 06:47 PM
quality of service?
05-16-2008 11:40 PM
or you can use the policy based routing. In PBR you can match the source and assign the next hop addresses.
regards
shivlu
05-17-2008 01:42 AM
You may be having definite reasons for doin this, otherwise make full use of the pipe you are paying for. There are some QoS techniques for doing this. Rate-limiting, shaping & policing are some features.
Refer this link for understanding:
http://www.cisco.com/en/US/docs/ios/12_0/qos/configuration/guide/qcpolts.html
05-17-2008 02:20 AM
For outbound, but not practical for inbound, if your routers support OER/PfR, you can configure load ratios.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: