2811 HWIC 4 ESW

Unanswered Question
May 18th, 2008
User Badges:

Hello All,


I have a Cisco 2811 running IOS adventerprisek9-mz.12.4-15.T and a

HWIC-4ESW POE installed. When I plug in a 7960 phone it does not power up....thoughts please


Thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Paolo Bevilacqua Sun, 05/18/2008 - 23:30
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Do you have the POE PS ? "show env" to know.

Paolo Bevilacqua Mon, 05/19/2008 - 07:50
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Do you have power inline under interface? Beside that I'd to see "show diag" and "show env".

Sushil Kumar Katre Tue, 05/20/2008 - 00:37
User Badges:
  • Gold, 750 points or more

Hi,


Can you please paste the show diag output and cross verify if you see "ILPM-4=" part number in that output.


Also check if the power supply which you have is "AC-IP".


-> Sushil

lagos Tue, 05/20/2008 - 04:35
User Badges:
  • Cisco Employee,

If you have the ILPM module for the HWIC and a POE enabled power supply in the router - make sure you have the cable that runs from the poe supply to the motherboard.


HTH.

Jason Aarons Tue, 05/20/2008 - 10:32
User Badges:
  • Bronze, 100 points or more

Likely power supply is not AC-IP model.

Actions

This Discussion