Frame-Relay Upgrade

Unanswered Question
May 19th, 2008
User Badges:

Hi,


I had recently requested an upgrade from my service provider on one of my frame-relay site. Is there a way to verify if an upgrade has been done on my pvc?


Regards.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Pravin Phadte Mon, 05/19/2008 - 04:29
User Badges:
  • Silver, 250 points or more

check the input and output packets on the interface.

guruprasadr Mon, 05/19/2008 - 04:33
User Badges:
  • Gold, 750 points or more

HI [Pls RATE if HELPS]


Use the WAN KILLER Tool to TEST the Circuit.


Using the Tool you can PUMP the Traffic to until your requested Bandwidth. Observe the Input & Output rate on the WAN Interface.


Hope I am Informative.


Pls Rate if HELPS


Best Regards,


Guru Prasad R

1lumkk Mon, 05/19/2008 - 18:44
User Badges:

Hi there,


Thanks for the info but appreciate if you can give more details. How can i confirm the speed with the following sample:


48482432 packets input, 1326954085 bytes, 0 no buffer

21114144 packets output, 2743938039 bytes, 0 underruns


Many thanks.

guruprasadr Mon, 05/19/2008 - 19:53
User Badges:
  • Gold, 750 points or more

HI, [Pls Rate if HELPS]


Pleaes execute the below command and paste:


Router#sh int Gi3/3 | i rate

Queueing strategy: fifo

30 second input rate 15582000 bits/sec, 9299 packets/sec

30 second output rate 58686000 bits/sec, 12625 packets/sec


Refer the "INPUT & OUTPUT" Rate value in the output above and they calculated in bits/sec.


Hope I am Informative.


Pls Rate if HELPS


Best Regards,


Guru Prasad R

Actions

This Discussion