Port channel on 3020 interconnects

Unanswered Question
May 19th, 2008


I am trying to configure some 3020 blade center interconnects for an HP blade center for the first time.

I have placed 3 interfaces in a port channel on the interconnect and upstream switch. However the port-channel is down and down on both devices. The respective interfaces are up and up, except for the Gi0/1 interface on the interconnect which is set to track the state of the relevant port channel.

If I remove this link state tracking, the interface relating to the blade comes up and I can ping the interconnect from the blade and vice versa, but cannot ping from the interconnect to the upstream switch.

The interconnect and switch configs are attached.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion