Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
431
Views
0
Helpful
3
Replies

Can't connect

unclematt
Level 1
Level 1

‎05-19-2008 07:34 AM - edited ‎07-03-2021 03:53 PM

I have some problems with a aironet 1130ag access point.

it lost signal strength over the period of a week so i did a factory reset on it. now, after setting it back up (very basic) i can't connect to it at all. can't descover it or connect. it has an ip and you can ping it.

Thanks in advance for any sugestions.

Labels:
0 Helpful
3 Replies 3

jeromehenry_2
Level 3
Level 3

‎05-19-2008 11:41 PM

Is in in LAP (LWAPP) or autonomous mode? Can you telnet to it? Check if radios are on if it is autonomous... if it is in LWAPP mode, try debug LWAPP client from the console...

0 Helpful

Chris Illsley
Level 3
Level 3

‎05-20-2008 04:55 AM

Telnet or console to it, check the radios are up, radios are off by factory default.

0 Helpful

Chris Illsley
Level 3
Level 3

‎05-20-2008 04:58 AM

Telnet or console to it, check the radios are up, radios are off by factory default.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card