05-20-2008 03:48 AM - edited 03-03-2019 10:00 PM
Dear Exper,
I would like to ask you about load sharing on Router 1841,let me tell on int f0/0 connect to ISP1(PPoE),F0/1 connect to ISP2 (Static IP) and int f0/0/0 connect to switch.and i would like to do ip address start from 10-50 go though ISP1 and ip address start from 60-100 go though ISP2.
Could you let me know how to configure and do you have sample command for this?
Best Regards,
Rechard_HK
05-20-2008 04:09 AM
hi richard,
you can use Policy based routing to divert the traffic to first isp and rest to remaining isp.
rgds
shiva
05-20-2008 04:12 AM
Dear shiva,
Do you have any document? if possible could you send to me.
thanks you for your time.
Best regards,
Rechard_HK
05-20-2008 09:01 PM
Dear All,
Do you have any advice on load sharing on cisco Router 1841?
Best Regards,
Rechard_HK
05-20-2008 09:51 PM
hi richard,
this link explains how to configure routemaps and policy based routing
http://www.ciscopress.com/articles/article.asp?p=102092
rate if it helps
rgds/shiva
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide