accessing CUE http

Answered Question
May 21st, 2008
User Badges:

Hi. i remember that when I implimented my CUE module on my UC520, if I went to the CUE module IP address in IE, i'd get all the CME stuff, plus the CUE html too.


Ive got a 2801 now, and i've implimented the CCME html and that works OK, but when I go to the CUE IP address, nothing loads. Where shall I start!


Thanks

Correct Answer by Paolo Bevilacqua about 8 years 10 months ago

Davie, "no shutdown" will help you a lot.

Correct Answer by Paolo Bevilacqua about 8 years 10 months ago

If CUE's address is take from voice or data vlan as usually happens, you should have a route like x.x.x.x 255.255.255.255 se0/0. This in addition to correct config under se0/0.



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
Correct Answer
Paolo Bevilacqua Wed, 05/21/2008 - 06:39
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

If CUE's address is take from voice or data vlan as usually happens, you should have a route like x.x.x.x 255.255.255.255 se0/0. This in addition to correct config under se0/0.



davieshuw Wed, 05/21/2008 - 06:44
User Badges:

Hi mate.


I've decided not to go with VLAN's on this implimentation as its only a small set up (and fancied a change)


I've configured:


interface Loopback0

ip address 192.168.150.1 255.255.255.252



interface Service-Engine0/0

ip unnumbered Loopback0

shutdown

service-module ip address 192.168.150.2 255.255.255.252

service-module ip default-gateway 192.168.150.1


ip route 192.168.150.2 255.255.255.255 Service-Engine0/0




Correct Answer
Paolo Bevilacqua Wed, 05/21/2008 - 06:59
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Davie, "no shutdown" will help you a lot.

davieshuw Wed, 05/21/2008 - 07:18
User Badges:

ah... thats rather embarrasing!


(..picks up ICND 1 for Dummies)


Thanks man!!

Actions

This Discussion