I wanna know if is any way to find the flash memory size in a Pix 515 with PIX Version 4.4(4)
Here my show version (there is no command like show flash, dir , etc)
pixfirewall> show ver
PIX Version 4.4(4)
Compiled on Thu 06-Jan-00 16:07 by pixbuild
PIX BIOS Cisco Secure PIX Firewall BIOS
pixfirewall up 2 mins 3 secs
Hardware: PIX-515, 64 MB RAM, CPU Pentium 200 MHz
Flash strata @ base 0x300
0: ethernet0: address is 0050.54ff.4a74, irq 10
1: ethernet1: address is 0050.54ff.4a75, irq 7
Ports allowed: 2
If I open the case (the case is selled), is there any indication in the memory card if the memory is 2MB/8MB/16MB ??
Thanks in Advanced,
My Best Regards,
You have 16mb flash.
I know it's a little cryptic as I had been in this situation long time ago when I started using the PIX.
Q. How do I determine how much Flash memory my PIX has?
A. If you perform a show version command on your PIX, and the Flash size is not given in MB, then use this table to see how much Flash your PIX has.
i28F020 512 KB
AT29C040A 2 MB
atmel 2 MB
i28F640J5 8 MB - PIX 506 16 MB - all other PIXes
strata 16 MB