05-21-2008 03:14 PM - edited 03-15-2019 10:48 AM
Someone know if in the CCM 5.0(4) version , the FAC is displayed in the CDR, i know that in the 5.1(3)version it can but i think that this is an unsupported feture in the version 5.0(4)
http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/service/5_1_3/car/caranrpt.html
05-21-2008 06:17 PM
AFAIK the DB scheme is the same for the 5.x version so the FAC should be in there
HTH
javalenc
if this helps, please rate
05-21-2008 09:05 PM
Hi javalenc,
Please check the document Getting Started with CDR Analysis and Reporting, it is diferent in the part of Display FAC in CDR because it apears only in the guide of the 5.1(3) version.
http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/service/5_0_4/car/caranrpt.html
http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/service/5_1_3/car/caranrpt.html
05-21-2008 09:13 PM
think ur right, the doc for handling the reports only show CMC as an option
http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/service/5_0_4/car/carsyrpt.html#wp1086010
HTH
javalenc
if this helps, please rate
05-22-2008 02:46 PM
I just loaded up 5.0(4) and don't see an option for "Display FAC in CDR". That comes in with 5.1 service parameters.
Don
06-23-2008 10:57 PM
now I have problem CUCM5.1 CDR csv export is not included FAC.
I already choose In the Clusterwide Parameters (Device - General), Diaplay FAC in CDR set to "True"
But in the CDR export csv file is not shown FAC in any colume.
Is there is anybody found the same problem like this?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: