05-22-2008 09:42 AM - edited 03-05-2019 11:10 PM
Hi all. I am completely new to Cisco Routers. before i had the Linksys WRV 200 and all i had to do is enter a static DSL IP, Mask, Gateway(the Routers IP) and DNS
Here on the 871 i can't even get the internet working correctly.
I have read some posts that people are setting up the Routers from the command line. Can i set it up from the SDM interface?
Please someone explain to me and maybie describe a simple setup where my Public Static (Internet) IP is 213.7.255.130 , DNS 213.7.255.129 , Net IP 213.7.255.128 and my private network which i have on a Hub that connects to the ETH0 of the router begins from 192.168.1.0 and goes untill 200
Please if it's not too much trouble explain to me how this is done. I have no idea what to do here so any description would be VERY helpful. If someone could explain to me and guide me through on how to do this and NOT redirect me to a link that would be very helpful.
Once again TNX in advance.
05-22-2008 11:19 AM
Yes it can be can be done using SDM.
Below are the 2 links which will help you with basic config on this device.
http://www.cisco.com/en/US/docs/routers/access/800/850/software/configuration/guide/enetintr.html
http://www.cisco.com/en/US/docs/routers/access/800/850/software/configuration/guide/routconf.html
05-22-2008 10:54 PM
05-23-2008 11:34 AM
Hi Demetris,
You have assigned your Public ip to a fastethernet interface. That wont work. Add the following in your config
no interface FastEthernet4
interface ATM0
no ip add
no shu
dsl operating-mode auto
interface ATM0.10 point-to-point
pvc 0/100
pppoe-client dial-pool-number 1
interface Dialer0
no shu
ip address negotiated
ip nat outside
encapsulation ppp
dialer pool 1
dialer-group 1
ppp authentication pap callin
ppp pap sent-username
no ip route 0.0.0.0 0.0.0.0 FastEthernet4
ip route 0.0.0.0 0.0.0.0 dialer0
no ip nat inside source list 1 interface FastEthernet4 overload
ip nat inside source list 1 interface dialer0 overload
Then post your new config and let me check if missing conf exists
Regards
05-25-2008 10:22 PM
Tnx for the reply. I will try this but before i do i want to ask:
ppp pap sent-username
why do i have to set a Dialer? and what Username and Password should i enter?
My connection is ADSL. So the ADSL modem is already connected. So what am i doing here?
05-26-2008 06:49 AM
Oh sorry, I mis read the model, thought it was a 877.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide