monitor session

valides007 · ‎05-22-2008

Hi guys,

I'm having hard time to make my voice recorder works with CME.

The CME is connected to port 5 on a 3560 cisco switch while the Exacom voice recorder is connected to port 30.

Here is the command i passed in the cisco switch:

monitor session 1 source int gi0/5 both

monitor session 1 destination int gi0/30

The voice recorder is able to recorde only one end of the call. I'm wondering if i need to add certain commands on either the cisco switch, or the CME.

any ideas?

marcwestberg · ‎05-23-2008

Try enabling inpkts

monitor session 1 source int gi0/5 both inpkts enable

This will look at both ingress and egress packets on the interface.