05-22-2008 02:54 PM - edited 03-15-2019 10:50 AM
I am trying to get into the greeting management system. I defined 298 under call handling and associated it with promptmgmt application. However when I call 298 from a phone I get a busy tone. It seems like I am missing something, but what? We are using 200 for AA and 299 for pilot number.
Thanks,
Diego
Solved! Go to Solution.
05-22-2008 03:05 PM
Check your dial peers...You should have a dial peer similar to the following
dial-peer voice 298 voip
description GMS dial-peer
destination-pattern 298
session target ipv4:x.x.x.x [ip of cue module]
session protocol sipv2
dtmf-relay sip-notify
Hope that helped
05-22-2008 03:05 PM
Check your dial peers...You should have a dial peer similar to the following
dial-peer voice 298 voip
description GMS dial-peer
destination-pattern 298
session target ipv4:x.x.x.x [ip of cue module]
session protocol sipv2
dtmf-relay sip-notify
Hope that helped
05-22-2008 03:18 PM
Nice, that helped a lot!! Now that I am looking at the dial-peers I see that the AA and pilot dial peers have some additional commands. They are:
b2bua
codec g711ulaw
no vad
What is b2bua? Are these needed for the GMS?
Thanks,
Diego
05-23-2008 05:51 AM
Im not too sure about b2bua, but I forgot the codec g711ulaw, you would most definitely need that, as CUE talks only in g711ulaw.
05-23-2008 06:01 AM
Yes, I had to add the codec. Thank you for your help.
Diego
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: