05-22-2008 07:48 PM - edited 03-05-2019 11:11 PM
I want to ask is it possible to convert a layer 3 switches into layer 2 switch.
05-22-2008 09:18 PM
hii, as per my experience the l3 switch would work as L2 only unless u gave command ip routing from CLI.
05-22-2008 10:30 PM
Mate, Just type the following command in.
no ip routing
:)
05-22-2008 10:33 PM
hiii i want to knw if ip routing is enable by default on l3 switches?
05-22-2008 10:48 PM
It is.. at least the 4948 series has it on by default..
As they l3 switches run IOS, and ip routing is turned on by default in IOS (I think since IOS 11 or so..) its a logical assumption that its on by default.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: