MLPPP with HWIC-4T1/E1 card...

Unanswered Question
May 23rd, 2008

I've done tons of T1s (with the old T1 WIC card), and tons of frame-relay, but this is my first time doing MultiLink PPP. Can someone scrub the config below, to see if it's OK? I'm using five (5) individual T1s; and the carrier said they're all in "up/down" state; no line-protocol. I see the same on my side, everything is "up/down". Am I missing something having to do with PPP? Router is a new 2851, and the IOS i'm running is shown in the config.


Config is attached!

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
abatson Fri, 05/23/2008 - 05:51

Original poster here: It's been a while since I've configured a T1 controller, I usually deal with the WIC-1DSU-T1's.

I think I see my error:

If I'm using "channel-group 1 timeslots 24", this means I'm using the 24th channel ONLY, not "all 24 channels", correct?

I need to use "channel-group 1 timeslots 1-24", correct? I guess I interpreted "timeslots" to mean the number of timeslots, not the range of timeslots.

If this is fixed, does the config appear OK?

aravindhs Fri, 05/23/2008 - 08:07

Hi there,

Remove the command from both the routers -

multilink bundle-name authenticated




This Discussion