jeromehenry_2 Fri, 05/23/2008 - 06:56
User Badges:
  • Silver, 250 points or more

Yes, ports are in trunk mode.

Hope it helps


Jerome

George Stefanick Sun, 05/25/2008 - 04:46
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Best Publication, October 2015

let me take that one step further. You can use a trunk or access ports for AP connectivity. The LWAPP tunnel will cross over either. I have deployed these over a MPLS network over switch port.




harish_chopra1 Thu, 11/10/2011 - 19:00
User Badges:

whatv vlans we should allow in trunk port ?

in my scenario, we have MPLS network in between.

Pls. explain if possible. Thanks !

Scott Fella Thu, 11/10/2011 - 19:04
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 Wireless

For an H-REAP AP, you need to trunk only the vlan your ap management ip address is on and any of your vlans you wish to put wireless users on (local switching). If you are centrally switching any SSID's, you do not need to add those vlans to the trunk port.


Sent from Cisco Technical Support iPhone App

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode