Need configuration assistance on Cisco ASA 5510 please

Unanswered Question
May 23rd, 2008


first time ocnfiguring ASA. I have configure two ASA devices, Promary and secondar and the failover seem to be working but I have routing issues in which I cannot reach devices behind the ASA.

both Inside and Outside Interfaces have Public IP addreses and customer doesn't want NAT. I have added static router inside to the inside block gateway IP which is on the core router. and also static outside 0/0 outside interface.

I havenot done any translation and think that might have contributed to this problem but wanted to see if I need to create a global outside interface since i have no NAT?



I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
husycisco Sat, 05/24/2008 - 06:31

Hi Masood

If customer doenst want NAT, simply issue "no nat-control" in firewalls and do not spend time on exempt nat statements


m-abooali Sat, 05/24/2008 - 09:11

Hi and thanks for your input.

The problem was due to the stupid "no proxy Arp" on the inside Interface!

that was scrwing up all the routing that I had in there. so upon disabling the proxy Arp on the inside interface all the servers behind the firewall were able to hit th eInternet!




This Discussion