cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
283
Views
0
Helpful
6
Replies

FXO to IPphone

miskoolak
Level 1
Level 1

Dear all

i Have fxo port on my voice gateway

i define connection plar on my FXO voice-port.and also defined sutable dial-peer to route the connection plar into CCM.

but when I dial the number i hear just fastbusy!

i debuged and saw theat the connection plar and dial-peer matches.

any idea?

6 Replies 6

paolo bevilacqua
Hall of Fame
Hall of Fame

First of all plar opx is always better than just plar.

Then chances are the CCM refuses the call, do you have codec g711u and no var under DP ?

Hope this helps, please rate post if it does!

yes both no vad and codec g711u is under dial-peer

but still ccm reject the call and i have fastbusy signal

Have you configured the router as gw in the ccm ?

:)) yes of course!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

If you read the cch323 or ccapi trace, you should see a reason for the reject.

Hi,

I am sure you have set significant digits, incoming CSS on GW correctly and destination-phone is registered to ccm. If not ideally you should get error-message from CCM rather then fast busy tone, but you've not specified CCM Version and there are bugs in CCM 5.0 which prevents message from CCM so I thougt of mentioning it.

If possible share debug voice ccapi inout.

thanks,

inner_silence

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: