05-24-2008 09:43 AM - edited 03-15-2019 10:51 AM
Dear all
i Have fxo port on my voice gateway
i define connection plar on my FXO voice-port.and also defined sutable dial-peer to route the connection plar into CCM.
but when I dial the number i hear just fastbusy!
i debuged and saw theat the connection plar and dial-peer matches.
any idea?
05-24-2008 09:52 AM
First of all plar opx is always better than just plar.
Then chances are the CCM refuses the call, do you have codec g711u and no var under DP ?
Hope this helps, please rate post if it does!
05-24-2008 10:10 AM
yes both no vad and codec g711u is under dial-peer
but still ccm reject the call and i have fastbusy signal
05-24-2008 10:25 AM
Have you configured the router as gw in the ccm ?
05-24-2008 10:26 AM
:)) yes of course!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
05-24-2008 10:28 AM
If you read the cch323 or ccapi trace, you should see a reason for the reject.
05-25-2008 10:54 AM
Hi,
I am sure you have set significant digits, incoming CSS on GW correctly and destination-phone is registered to ccm. If not ideally you should get error-message from CCM rather then fast busy tone, but you've not specified CCM Version and there are bugs in CCM 5.0 which prevents message from CCM so I thougt of mentioning it.
If possible share debug voice ccapi inout.
thanks,
inner_silence
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide