cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
656
Views
5
Helpful
5
Replies

Cisco 1811w

tu_amor66
Level 1
Level 1

I would like to know if there is something I can do to allow wireless traffic to the local LAN.

My config is attached. i have Vlans 1-5, 1&2 are for the lan, 3-5 are for wireless. I cannot access resources on the LAN with either.

5 Replies 5

andrew.prince
Level 10
Level 10

Edgar,

Enter the below under the main lan interface:-

bridge-group 1

no bridge-group 1 source-learning

bridge-group 1 spanning-disabled

HTH.

I apologize, I have since changed my config,hoping to correct the issue. I removed the bridging that was associated with it, but I still have the same issue.

Disregard,I figured it out.

I removed the deny ip any 10.10.1.0 0.0.0.255.

I do appreciate the help.

access-list 111 permit ip 10.10.1.0 0.0.0.15 host 10.10.1.1

access-list 111 permit ip any 10.10.1.0 0.0.0.255

access-list 111 permit ip 10.10.1.0 0.0.0.15 any

access-list 111 permit udp any any eq bootpc

access-list 111 permit udp any any eq bootps

access-list 111 deny ip any any

You have removed ALL the wireless config?

No, the wireless is still configured, I just removed the bridging, and the network performs great. The appropiate Vlans are segmented and protected, Thanks for you help .

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: