Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
477
Views
0
Helpful
2
Replies

Question about the command to force the standby CSM to be active

Go to solution
snakayama
Level 3
Level 3

‎05-25-2008 08:00 PM

Hi everyone,

Is there any command to force the standby CSM (Content Switching Module on Catalyst 6500) to be active ?

such as "redundancy force-master" command on CSS.

I can not find such command on CCO.

Your information would be appreciated.

Regards,

Labels:
0 Helpful
1 Accepted Solution

Accepted Solutions

Go to solution
Syed Iftekhar Ahmed
Level 8
Level 8

‎05-27-2008 01:23 PM

clear module csm x ft active

(make sure peremption is disabled befor you run this command).

Thanks

Syed

View solution in original post

0 Helpful
2 Replies 2

Go to solution
Syed Iftekhar Ahmed
Level 8
Level 8

‎05-27-2008 01:23 PM

clear module csm x ft active

(make sure peremption is disabled befor you run this command).

Thanks

Syed

0 Helpful

Go to solution
snakayama
Level 3
Level 3
In response to Syed Iftekhar Ahmed

‎05-27-2008 08:16 PM

Syed,

Thank you very much for your reply.

Shinichi

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents