05-25-2008 11:30 PM - edited 03-05-2019 11:13 PM
Hi everyone,
I have the question about the lithium battery on MSFC.
Is there any command to display voltage of lithium battery to confirm whether the life of lithium battery is lost.
I can not find related information on CCO.
Your information would be appreciated.
Regards,
Solved! Go to Solution.
05-30-2008 06:39 AM
To monitor the voltage or health of the battery, I have not seen any CLI command that displays information on the battery status.
There is a simple battery check built into the NVRAM component. When there is a drop in the battery voltage, the NVRAM generates a 'battery low' signal. This is used to notify SW of this condition. SW then generates the 'NVRAM low battery' error message. Since the battery is entirely enclosed within the NVRAM component, there is no other way to monitor battery health in a more direct manner.
05-30-2008 06:39 AM
To monitor the voltage or health of the battery, I have not seen any CLI command that displays information on the battery status.
There is a simple battery check built into the NVRAM component. When there is a drop in the battery voltage, the NVRAM generates a 'battery low' signal. This is used to notify SW of this condition. SW then generates the 'NVRAM low battery' error message. Since the battery is entirely enclosed within the NVRAM component, there is no other way to monitor battery health in a more direct manner.
06-01-2008 05:21 PM
Thank you very much for your reply.
I understand it.
Regards,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide