05-26-2008 02:16 AM - edited 07-03-2021 03:55 PM
Hi,
We have a mesh implementation, the problem is this: it takes 3 - 4 hours for the MAP to register to the WLC. Has anyone experienced this before? Has anyone have an idea why it takes this long? By the way, This is just a point-to-point mesh network. Thanks.
05-26-2008 09:52 AM
This was a common problem in older code releases. What version of code are you running on the Controller, and what model MESH AP's are you using?
05-26-2008 07:00 PM
Hi,
We're using the newest version 4.1.192.22M MESH. The APs are both 1242AG converted to LWAPP.
05-27-2008 04:01 AM
Do you have the MAC addy of the AP added into mac filtering section? If not, it will associate eventually but as a blacklisted AP.
05-27-2008 10:55 PM
Hi,
Yes, the MAC address has already been added to the WLC. This is the scenario that we've done: we tested how fast the MAP would register to the WLC several times by doing power cycles on the MAP. Sometimes it would register in just 5 mins and sometimes it takes 3 hours to register.
07-14-2008 04:00 AM
We experience the same problem. We have 4 RAPS and 23 MAPS(1522 AP's on 4402 controller 4.1.191.24M software). Convergence of the MESH takes between 2 - 4 hours to converge. Was there any resolution of your problem?
07-14-2008 06:20 AM
there is a dhcp scope with the proper VCI identifier for your MESH APs and OPtion 43 enabled right? Did you add the bridge group name as well?
07-14-2008 10:52 PM
Yes, we have all of this configured. The Mesh is up, but when we loose one of the AP's due to a power failure it takes 2-4 hours to converge.
08-05-2008 10:38 AM
Could be to do with a mismatch of bridge names between APs.
09-16-2008 12:44 AM
The bridge group names are the same on both. Sometimes the MAP registers quickly.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide