16 interfaces into one bundle MLPPP

Unanswered Question
May 26th, 2008

could you please help

i have 7200 vxr with nbe 400 and Iwant to configure 16 serial interfaces in one bundle.

when I do so the router crashes although I used 12.4(5) version please note that I used STM-1 interface channalized.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
guruprasadr Mon, 05/26/2008 - 05:26

HI, [Pls Rate if HELPS]

Refer the Previous / earlier POST discussed regarding the same Topic:

http://forums.cisco.com/eforum/servlet/NetProf;jsessionid=34785B481D8753544662D1B2A7C7684A.SJ2A?page=netprof&forum=Network%20Infrastructure&topic=WAN%2C%20Routing%20and%20Switching&topicID=.ee71a06&fromOutline=&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.2cc005cb

Hope I am Informative.

Pls Rate if HELPS => Use the Rating System

Best Regards,

Guru Prasad R

m_tarawneh Mon, 05/26/2008 - 05:53

Dear

thank you for your response but i asked aboout 7200 vxr nbe400 ram 256

the previous document about 7500 3800 which is not my platform

Paolo Bevilacqua Mon, 05/26/2008 - 05:29

Hi, it is not said that 12.4(5) is the best release for a 7200. For intensive, ISP-like use on 7200 routers, the most stable is 12.2S, currently 12.2(12)S13.

m_tarawneh Mon, 05/26/2008 - 05:47

I have traid many ios's such 12.3.(23)

and the latest 12.4(19)LD

Paolo Bevilacqua Mon, 05/26/2008 - 06:02

As mentioned above, for intensive use, the most stable and reccomended version is 12.2S.

m_tarawneh Mon, 05/26/2008 - 06:10

ok but do you think that 16 interfaces can bundle on 7200 vxr or its limit is 8 interfaces only

Actions

This Discussion