Cisco 2821 + VWIC2-2MFT-T1/E1

Answered Question
May 26th, 2008
User Badges:

Hello.

I would like to know how much physical interfaces i may to include on MLPPP configuration using the Cisco 2821 with VWIC2-2MFT-T1/E1

Correct Answer by paolo bevilacqua about 9 years 2 months ago

You can have a maximum of 16 links in a bundle, doesn't matter what is physical interface type. For high density now there is a new NM with 8 T1/E1, for example. or the hwic-ce1/t1-pri that is made specifically for data and a bit cheaper than the vwic2.


Hope this helps, please rate post if it does!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (3 ratings)
Loading.
JORGE RODRIGUEZ Mon, 05/26/2008 - 09:58
User Badges:
  • Green, 3000 points or more

With VWIC2-2MFT-T1/E1 you get 2 T1s or 2 E1s.


Uses 1 WIC slot,2 physical serial interfaces.


Typical scenario for two T1s MLPPP example assuming you are using WIC0 slot.


controller T1 0/0/0

framing esf

linecode b8zs

channel-group 0 timeslots 1-24


controller T1 0/0/1

framing esf

linecode b8zs

channel-group 0 timeslots 1-24



interface Serial0/0/0:0

no ip address

encapsulation ppp

fair-queue

ppp multilink

ppp multilink group 1


interface Serial0/0/1:0

no ip address

encapsulation ppp

fair-queue

ppp multilink

ppp multilink group 1


interface Multilink1

bandwidth 3088

ip address x.x.x.x

fair-queue

ppp multilink

ppp multilink group 1



HTH

-Jorge






leal_luiz Mon, 05/26/2008 - 10:25
User Badges:

What the maximum of VWIC i can add on this multilink?

Correct Answer
paolo bevilacqua Mon, 05/26/2008 - 10:49
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

You can have a maximum of 16 links in a bundle, doesn't matter what is physical interface type. For high density now there is a new NM with 8 T1/E1, for example. or the hwic-ce1/t1-pri that is made specifically for data and a bit cheaper than the vwic2.


Hope this helps, please rate post if it does!

Actions

This Discussion