Dial Peer configuration

Answered Question
May 26th, 2008

Folks, when I try to add a dial peer to a

cisco 3825 running IOS c3825-spservicesk9-mz.124-11.T4.bin

I get the following error:

ERROR: could not add peer

Do you know what do I need to do ?

thank you

I have this problem too.
0 votes
Correct Answer by Paolo Bevilacqua about 8 years 5 months ago

No, it's a bug. reload the router and you will be able to add the DP.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Kenneth Mohammed Mon, 05/26/2008 - 11:02

I have seen this error before, and usually its because you dont have enough memory left to add another dial peer.

cris_jimenez Mon, 05/26/2008 - 11:10

that's what I thought

hq-3825-voip#show memory free totals

Head Total(b) Used(b) Free(b) Lowest(b) Largest(b)

Processor 65A72950 137942704 127195068 10747636 10316808 8275968

I/O 2DE00000 35651072 11544380 24106692 22423504 23751420

do you think I need to add more memory ?

thank you

Paolo Bevilacqua Mon, 05/26/2008 - 12:10

No sweat. If you could convince that TAC that's a bug and get it filed, that would be a big favor to the community. Unfortunately it's very difficult.

Thanks for the nice rating and good luck!

Paolo Bevilacqua Mon, 05/26/2008 - 11:03

You ran into a memory leak that to my knowledge has not been fixed yet. I have encountered it on all releases but 12.4XC. Only solution is reload the router, but it will happen again.

So if you don't want to downgrade, preconfigure all the DPs that you plan to need in the future.

Hope this helps, please rate post if it does!


This Discussion