Dynamic IOS to static ASA 8.x, how to use other than DefaultL2LGroup?

Unanswered Question
May 26th, 2008

Using DefaultL2LGroup tunnel-group, I am able to bring up a L2L tunnel from an IOS Cisco871 hub that is dynamically addressed to a static spoke ASA running 8.x. Authentication is via PSK. How can I use a tunnel-group other than DefaultL2LGroup? It seems like I would have to pass a tunnel-group name from the IOS spoke to the ASA during Phase 1, but I can't see how to do that.

Thanks.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
kbyrd Mon, 05/26/2008 - 15:01

Thanks for the link, but that was for EZ VPN. I have a dynamic map. It actually works. I just want to use a TG other than DefaultL2LGroup

Actions

This Discussion