Inbound queue???

Unanswered Question
May 26th, 2008

Is the Ironport have INBOUND or HARD queue? I am asking because I met this question in the certification program and I can not found this information in the books and user guides.


Many thanks

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
kluu_ironport Wed, 05/28/2008 - 18:31

You can find information about the delivery queue by typing "tophosts" from the command line.


Here is some kb information that may be useful.

How do I view the status and number of messages in the IronPort appliance message queue?

http://tinyurl.com/qk4y8

How to troubleshoot delivery issues

http://tinyurl.com/y6ub9n


Is the Ironport have INBOUND or HARD queue? I am asking because I met this question in the certification program and I can not found this information in the books and user guides.


Many thanks
bfayne_ironport Thu, 05/29/2008 - 22:34

Is the Ironport have INBOUND or HARD queue?



The INBOUND queue would be the workqueue. That is where messages end up immediately after reciept and while they are being processed. You can type 'workqueue status' from the CLI to find out how many messages are in the queue.

Try using 'workqueue rate x' where x is a number in seconds to refresh to see an updating status display.
steven_geerts Fri, 05/30/2008 - 00:40

Try using 'workqueue rate x' where x is a number in seconds to refresh to see an updating status display


That's a good tip bfayne!
I had not found that one, thank you!

Actions

This Discussion