05-27-2008 06:41 AM - edited 07-03-2021 03:56 PM
Guys,
I have two 4404s connected to two different 6500 switches.
They have two ports connect to each switch in LAG mode. Lets say 1/1 and 2/1 on the 6500s.
When I do a show cdp nei from the 6500, on port 1/1 I see two entries showing the local interface as 1/1 and the remote interfaces being unit 0 slot 0 port 1 and unit 0 slot 0 port 2.
On port 2/1 i see no cdp neighbor entries?
Is this normal and just cosmetic?
Thx
Ken
05-27-2008 07:29 AM
You have the etherchannel setup correctly on the 6500?
05-27-2008 07:58 AM
Yes it is. It is very strange :)
05-27-2008 08:01 AM
How do you have the etherchannel setup and the port-channel. You should see cdp on both ports.
What is the output on the show etherchannel
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: