Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
454
Views
0
Helpful
3
Replies

pri-group command not available

atosorigin
Level 1
Level 1

‎05-27-2008 01:00 PM - edited ‎03-03-2019 10:07 PM

Hi,

I would like to know why the pri-group command is not available under the controller xx submenu of my 2600XM router. It is running the following IOS c2600-advipservicesk9-mz.123-26.bin and have a VWIC-1MFT-G703 card.

Thanks a lot for your help.

Labels:
0 Helpful
3 Replies 3

paolo bevilacqua
Hall of Fame
Hall of Fame

‎05-27-2008 01:03 PM

Hi, for data only pri on the vwic, you can try with an non-voice image, else the recommended card is nm-xce1/t1.

0 Helpful

atosorigin
Level 1
Level 1
In response to paolo bevilacqua

‎05-27-2008 01:13 PM

I tried first with a ipbase image but I've got the same result. Moreover the pri-group command is available with the same card on 1841 platform.

0 Helpful

paolo bevilacqua
Hall of Fame
Hall of Fame
In response to atosorigin

‎05-27-2008 01:42 PM

The 1841 is very different. On the 2600 the only way to have data pri is the nm mentioned, or a the vwic in a nm-hdv with codecs.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card