Sending calls out remote router

Unanswered Question
May 27th, 2008

I have CUCM 6.1 with a main office and a branch office with gateway's in each location. I would like to be able if a call for example from the main office is within the area code of the remote office that we can send the call out that router. I was wondering the best way to do this.

Thanks in advance!

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Jaime Valencia Tue, 05/27/2008 - 16:28

configure the route patterns to use the GWs, that's toll bypass and it's all based on route patterns and to which GW each call needs to be routed

configure 1 route pattern for main office when dialing that area code and route it to that GW



if this helps, please rate

scottm65 Wed, 05/28/2008 - 07:46

I figured that was probably the best way to do it, thanks for the reply!


This Discussion