cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
342
Views
0
Helpful
2
Replies

Bonded ADSL Issue - 2811

anthonyfear
Level 1
Level 1

Hi All

I have a 2811 with 2 ADSL cards that are bundled using MLLP. Problem is the internet connection frequently (every couple of days) seems to slow right down almost to nothing, I get intermittent connection to the internet and struggle to telnet remotely onto the router - however if I keep trying, eventually I get onto the router (remotely) and perform a reload - then everything returns to normal speed.

Any Ideas?

Regards

Anthony

p.s.

I enclose a copy of a show ver - because i seem to recall hearing that there was bug that caused this (but I could be making that up?)

Router#show ver

Cisco IOS Software, 2800 Software (C2800NM-ADVIPSERVICESK9-M), Version 12.4(11)T

4, RELEASE SOFTWARE (fc3)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2007 by Cisco Systems, Inc.

Compiled Fri 26-Oct-07 19:38 by prod_rel_team

ROM: System Bootstrap, Version 12.4(1r) [hqluong 1r], RELEASE SOFTWARE (fc1)

Router uptime is 2 minutes

System returned to ROM by reload at 02:10:54 UTC Wed May 28 2008

System image file is "flash:c2800nm-advipservicesk9-mz.124-11.T4.bin"

This product contains cryptographic features and is subject to United

States and local country laws governing import, export, transfer and

use. Delivery of Cisco cryptographic products does not imply

third-party authority to import, export, distribute or use encryption.

Importers, exporters, distributors and users are responsible for

compliance with U.S. and local country laws. By using this product you

agree to comply with applicable laws and regulations. If you are unable

to comply with U.S. and local laws, return this product immediately.

A summary of U.S. laws governing Cisco cryptographic products may be found at:

http://www.cisco.com/wwl/export/crypto/tool/stqrg.html

If you require further assistance please contact us by sending email to

export@cisco.com.

Cisco 2811 (revision 53.50) with 249856K/12288K bytes of memory.

Processor board ID FCZ095371FK

2 FastEthernet interfaces

2 ATM interfaces

1 Virtual Private Network (VPN) Module

DRAM configuration is 64 bits wide with parity enabled.

239K bytes of non-volatile configuration memory.

62592K bytes of ATA CompactFlash (Read/Write)

Configuration register is 0x2102

2 Replies 2

smahbub
Level 6
Level 6

Can you provide the exact error message that you are getting while trying to access the internet which will help us in resolving the issue in a better way.You can check for any issues with cable connections and also the configuration done.

Hi There

As the system is remote from me and I'm unable to connect for any length of time prior to reboot - I'm afraid I haven't seen any errors.

From my end - it simply stops responding to pings intermittently (or rather it only responds to pings intermittently) and I have to repeatidly keep trying to telnet into the system until I'm, eventualy, able too - Then I reload and everything comes up fine again.

Does that help?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco