Cisco 3750 Stack no link with Wyse Winterm

Unanswered Question
May 28th, 2008

On a new Cisco 3750 stack implementation, all went well except a number of older Wyse Winterm thin clients. They do not get a link light, or any connection to the stack at all. I have switched out multiple cables and cable types as well as setting interface configurations for the devices (10mb/half duplex, etc) but have not been able to get the devices to come online.

I really don't know where to go from here.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
glen.grant Wed, 05/28/2008 - 09:07

Try setting the port speed and duplex as auto and then enable auto mdix on the port itself on the 3750 and see if you get a link light.

clamasters Tue, 06/17/2008 - 13:03

Sorry for the delayed response. It appears that on the 3750's the problem somehow fixed itself. However, I am now having the exact same issue on a Cisco 3560 switch with the same endpoint device type. I've already parsed the configs and found zero differences pertaining to the interfaces. An example of how basic the config is:

int f0/3

desc ##Nonworking WYSE##

sw acc vlan 3


This Discussion