Hoping you can help with this one..
On a MDS9124e switch installed in a HP C-Class Blade Enclosure I am seeing the port status as 'Externally Disabled' The port has acquired a license OK but will not come up.
The same problem was refrenced at http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Data%20Center&topic=Storage%20Networking&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.1ddf9f63/0#selected_message
But I cannot find any settings in the HP Onboard Admin that would enable a port on the fabric switch.
Any help would be greatly appreciated.