05-28-2008 05:54 PM - edited 03-03-2019 10:08 PM
I have an ASA doing NAT. I have two external routers, each on a different ISP/network. The routers are running BGP. I want to run OSPF between the ASA and the routers in order for the ASA to pick the default route based on BGP availability. Any idea where to start??
05-29-2008 01:08 AM
This would be as good a place as any to start. Have a read and come back if you have further questions
http://www.cisco.com/en/US/docs/security/asa/asa72/configuration/guide/ip.html#wp1094564
Jon
05-30-2008 01:42 PM
Starting with my external router.
Should the area between the two routers and the ASA be a normal area or a nssa area?? Is the config below okay for my two routers?? The two external routers are running BGP and
----------------
router ospf 100
network 0.0.0.0 255.255.255.255 area 10
default-information originate
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: