problem with route-map binding

Unanswered Question
May 28th, 2008
User Badges:
  • Silver, 250 points or more

I have a peer-group template and neighbors are binded in that template.

when i mention the command of route-map for a particular neighbor and that neighbor is also binded with the peer-group, in this case i am not able sepecify the out but in is working.



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Kevin Dorrell Thu, 05/29/2008 - 01:33
User Badges:
  • Green, 3000 points or more

You should bear in mind that a peer group is much more than just a template.

One of the main features of a peer group is that you must have the same outgoing policies for all the peers in the group. The idea behind the peer group is to save CPU time by compiling one set of updates only, and sending it to each of the peers in the group. Of course, for this to be viable, the outgoing route-map must apply to all peers in the group. That is why it will not allow you to attach the route-map to only one peer.

Kevin Dorrell


Richard Burts Thu, 05/29/2008 - 04:00
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN


Nice explanation. It deserves the rating that I gave it.

Congratulations on achieving your CCIE.



guruprasadr Thu, 05/29/2008 - 05:15
User Badges:
  • Gold, 750 points or more

Dear Kevin,

Congratulations on achieving your CCIE.

Best Regards,

Guru Prasad R


This Discussion