05-29-2008 12:43 AM - edited 03-15-2019 10:56 AM
Hello!
We have Cisco 2851 with two VWIC2-2MFT-T1/E1 - 2-Port RJ-48 Multiflex Trunk - T1/E1
!
card type e1 0 0
card type e1 0 2
!
I want monitoring active calls, but can see only for card 0/0:
# snmpwalk -c public -v 2c ROUTER 1.3.6.1.4.1.9.10.19.1.1.9
SNMPv2-SMI::enterprises.9.10.19.1.1.9.1.3.0.0 = Gauge32: 2
SNMPv2-SMI::enterprises.9.10.19.1.1.9.1.3.0.1 = Gauge32: 0
What can i do to start monitoring my card 0/2?
05-29-2008 03:56 AM
Anybody.. up
05-29-2008 04:10 AM
Does this help?
http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a00801abe59.shtml
Regards,
Michael.
05-29-2008 04:28 AM
Scratch that. I just realized the ISR series routers do not support the CISCO-POP-MGMT-MIB.
Researching still...
Regards,
Michael.
05-29-2008 04:43 AM
So the issue of ISR routers not supporting CISCO-POP-MANGAGEMENT MIB is documented in CSCee16176. You may want to use the CISCO-ISDN-MIB instead.
Regards,
Michael.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: