I have a Floating Static route and EIGRP problem.
At my main site I have a 3750 at the core of my switch environment running EIGRP in the same network as all my other devices. It sends traffic via a point to point connection to a processing site- this traffic flows to the left thru the ASA and 2811 (the 2811 is not ours -we do not have access to it's config). If the point to point to the processing center goes down I want traffic to re-route across the WAN-to the right- and out our 2nd point to point to the processing center.
The 1841 is using IP SLA and floating static routes. When the link goes down, it changes it's EIGRP table and sends traffic back to the 3750 and creates a loop. If I remove the link between the 3750 and the 1841 the 3750 learns the route thru the MPLS and works correctly.
What's wrong? I can provide Sho runs etc. if required