Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
278
Views
5
Helpful
1
Replies

soft block the T1 circuit

anitachoi3
Level 1
Level 1

‎05-29-2008 08:50 AM

Hi,

I have two AS5400 with 12 T1 cricuits. I would like to block the T1 circuits of one box for maintenance.

Does it have a command to block the T1 circuit after the voice call is completed? It is not necessary to block the channels one by one.

rdgs

Labels:
0 Helpful
1 Reply 1

smahbub
Level 6
Level 6

‎06-04-2008 06:15 AM

You can take a specified channel or an entire PRI interface out of service or put it into one of the other states that is passed in to the switch. To do so, complete the following task in interface configuration mode:

"AS5350(config-controller)# isdn service dsl number b_channel 0 state state-value"---- Sets the entire PRI interface to the specified state.

Refer the following link for more information on blocking T1 circuits in AS5400:

http://www.cisco.com/en/US/docs/routers/access/as5350/software/configuration/guide/54bas3_ps501_TSD_Products_Configuration_Guide

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents