I have the follow network diagram
I need the call start whit 909T going to Claro E1, but when call to 9T the call go to 2811 GW, for de PSTN E1
The configuration to as5350 and gw 2800 is:
AS5350 (172.24.10.5)
dial-peer voice 1 pots
tone ringback alert-no-PI
description ***E1 Claro***
answer-address 1700
destination-pattern 909T
direct-inward-dial
port 3/0:D
!
dial-peer voice 2 voip
answer-address 1700
description ***GW 2800***
destination-pattern 9T
voice-class codec 1
session target ipv4:10.38.172.150
dtmf-relay cisco-rtp
!
GW 2800 (10.38.172.150)
dial-peer voice 10 pots
tone ringback alert-no-PI
description ***LOCALES***
destination-pattern 9T
direct-inward-dial
port 1/0/0:15
!
When the 1700 call to 92442010 for example the calling match whit the dial-peer but the call it's incoming, and the call never go to GW2800
But when i make csim start 92442010 the call match to the dial-peer but outgoing call and call it recived but GW2800.
attach the network diagram and debug calls.
Thanks, sorry for the english.
fixie rider