fractional T3

Unanswered Question
May 29th, 2008

Hi, I am going to setup a new point to point internet link that is fiber. It is a fractional T3 (4.5Mbps) Is there anything that I have to setup for on this interface? I know that when setting up a fractional T1 you have to specify service time slots. Also do I have to specify the bandwidth of the connection? Thanks

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
PAUL TRIVINO Thu, 05/29/2008 - 11:57

On T3's my experience is that the "dsu-bandwidth" must match at both ends. I believe you can have a channelized T3 but I think it's unusual, especially for Internet.

Paul

Actions

This Discussion