Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1055
Views
0
Helpful
1
Replies

fractional T3

bsudol79p
Level 1
Level 1

‎05-29-2008 11:32 AM - edited ‎03-03-2019 10:09 PM

Hi, I am going to setup a new point to point internet link that is fiber. It is a fractional T3 (4.5Mbps) Is there anything that I have to setup for on this interface? I know that when setting up a fractional T1 you have to specify service time slots. Also do I have to specify the bandwidth of the connection? Thanks

Labels:
0 Helpful
1 Reply 1

PAUL TRIVINO
Level 3
Level 3

‎05-29-2008 11:57 AM

On T3's my experience is that the "dsu-bandwidth" must match at both ends. I believe you can have a channelized T3 but I think it's unusual, especially for Internet.

Paul

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card