×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Catalyst 3750 stack management

Answered Question
May 30th, 2008
User Badges:

Is it possible to set up a stack of switches in a way that you can ssh into a particular switch on the stack or do you have to go CLI to that switch from the master?


Not sure if there is something virtual that can be set up on the master. Just a question.

Correct Answer by Joseph W. Doherty about 9 years 2 months ago

Normally you manage a 3750 stack as a single switch. The stack member's ports appears much as the line cards do on a chassis switch.


You can SSH into the stack, again as a single virtual switch, if you have a IOS image that supports SSH and its configured.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Joseph W. Doherty Fri, 05/30/2008 - 15:51
User Badges:
  • Super Bronze, 10000 points or more

Normally you manage a 3750 stack as a single switch. The stack member's ports appears much as the line cards do on a chassis switch.


You can SSH into the stack, again as a single virtual switch, if you have a IOS image that supports SSH and its configured.

ryandm0tt Mon, 06/02/2008 - 06:26
User Badges:

Joe,


Thanks. That's what I figured, I just wanted to make sure that I wasn't sending the wrong info back up the chain.


You saved me a little work. I had thought about initially setting up some of the member switches with their own loopback0 IP addresses in hopes that when I stacked them, they'd retain that info, but from what I've seen, it does in fact just appear as one big healthy switch.


We'll roll with this.

Actions

This Discussion