1760 CCME 4.1 FXS problem

Unanswered Question
May 31st, 2008

Hi,

I'm trying to configure a VIC-2FXS on a Cisco 1760 running 12.4(15)T4 (CME 4.1) with an extention... After trawling the internet and the Cisco website i have found numerous articles referring to STCAPP... Problem is, if i do:

1760-CCME#config t

Enter configuration commands, one per line. End with CNTL/Z.

1760-CCME(config)#st?

stackmaker stacks standby state-machine

i only get the following options... =(

Did i miss something???

Any help would be greatly appreciated...

Thanks...

Regards,

Alan.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Michael Owuor Sat, 05/31/2008 - 07:50

Hello Alan,

Feature Mode for SCCP FXS Ports IOS is not available in the 1760, since this feature was introduces after that series of router went into End-of-Sale. There is therefore no development or introduction of new features for this platform.

These links lists the different platforms on which the feature is available

http://www.cisco.com/en/US/docs/ios/12_4/12_4x/12_4_6xe/htfeatmd.html#wp1053143

http://www.cisco.com/en/US/docs/ios/12_4t/12_4t2/ht1vg224.html#wp1310413

Hope this helps.

Regards,

Michael.

amcom Sat, 05/31/2008 - 07:56

Hi Michael,

Thanks for that... Are you able to provide any links or config to get an FXS port to act as an extension???

Thanks...

Regards,

Alan.

Paolo Bevilacqua Sun, 06/01/2008 - 04:33

FXS works pretty much like an extension, just configure a DP for it. If you need call transfer, search "h.450" here, for recommendation on how to set such script.

Hope this helps, please rate post if it does!

Actions

This Discussion