05-31-2008 05:44 AM - edited 03-17-2019 09:23 PM
Hi,
I'm trying to configure a VIC-2FXS on a Cisco 1760 running 12.4(15)T4 (CME 4.1) with an extention... After trawling the internet and the Cisco website i have found numerous articles referring to STCAPP... Problem is, if i do:
1760-CCME#config t
Enter configuration commands, one per line. End with CNTL/Z.
1760-CCME(config)#st?
stackmaker stacks standby state-machine
i only get the following options... =(
Did i miss something???
Any help would be greatly appreciated...
Thanks...
Regards,
Alan.
05-31-2008 07:50 AM
Hello Alan,
Feature Mode for SCCP FXS Ports IOS is not available in the 1760, since this feature was introduces after that series of router went into End-of-Sale. There is therefore no development or introduction of new features for this platform.
These links lists the different platforms on which the feature is available
http://www.cisco.com/en/US/docs/ios/12_4/12_4x/12_4_6xe/htfeatmd.html#wp1053143
http://www.cisco.com/en/US/docs/ios/12_4t/12_4t2/ht1vg224.html#wp1310413
Hope this helps.
Regards,
Michael.
05-31-2008 07:56 AM
Hi Michael,
Thanks for that... Are you able to provide any links or config to get an FXS port to act as an extension???
Thanks...
Regards,
Alan.
06-01-2008 04:33 AM
FXS works pretty much like an extension, just configure a DP for it. If you need call transfer, search "h.450" here, for recommendation on how to set such script.
Hope this helps, please rate post if it does!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide