I installed a VIC2-2FXO= into my 3845 router and am unable to configure the voice-port. I keep getting "unrecognized command" or "invalid input detected..." when I enter the following:
% Invalid input detected at '^' marker.
I have another 3845 which has the exact same card installed and it is working fine. I have already tested the card to see if it was bad and it is good and works in the other router. The ios versions are the same on both routers too. I have tried all 4 sub-slots in slot 0 on the router and get the same result. Could I have a bad slot 0 in this router or am I just missing some enable command for the card? Please help. I attached a text file of the show inventory command for reference.
If you need info about DSPs and PVDM:
This info can help you:
When you do a show diag and you have PVDM installed, your output should look like this, for example:
PVDM Slot 0:
64-channel (G.711) Voice/Fax PVDMII DSP SIMM PVDM daughter card
Check this to see how to install and remove PVDMs in 3800 series router:
For the voice cards to work you need to have DSP resources available on the router which is in form of PVDMs.
Your card has ben deteted properly by the router.
Check if you have enough DSPs on the router and paste the show diag output here.