I configure IPsec AES MD5 between two routers. The access-list is that.
permit icmp any any
Works ok .
After that i configure the access-list as
permit ip any any .
The remote router do not get the routes from the Hub router.
I use EIGRP protocol and the remote router is a stub router. Also i use EIGRP authentication between the two routers md5.
What might be the problem.
Thanks a lot
Another thing in the ACL you would change is deny traffic from IPSEC Source IP to IPSEC Destination IP so that the IKE negotiation happens else your IPSEC itself will not come up.
If you want to run EIGRP over IPSEC, maybe you should explore Virtual Tunnel Interfaces or Dynamic Multipoint VPN