Lan to Lan routing help needed

Unanswered Question
Jun 3rd, 2008
User Badges:

I am trying to set up a Lan to Lan connection for home users to connect back to the main office. I am using a ASA 5505 for the home and connecting back to a 3005 concentrator.


I have the tunnel built and working. When interesting traffic orginates at the remote client, the tunnel is built correctly.


My issue is that I cannot get the routing to update on both sides.

I have enabled RIP on both sides and set the 3005 to use network autodiscovery to update the routing table on both networks.


I either dont have the RIP configured correctly, or I need to enable the NAT rules, but its not making sense to me.


Any help?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Eliufoo.Mahinda Wed, 06/04/2008 - 00:09
User Badges:

Hi,


Add the following line under the crypto map mode


reverse-route remote-peer


Regards,

Elly

Actions

This Discussion