06-03-2008 12:01 PM - edited 03-18-2019 09:03 PM
We are deployinga CME/CUE 2851 Router with 1 PRI Connected to it. When we get Inbound Calls on the PRI, only the calling number is being displayed, not the calling party name. Is their something on the Gateway Inbound Dial Peer that has to be set? I have a direct inward dial statement in their on the Dial Peer. Or is it something from within the GUI I have to enable?
06-09-2008 01:07 PM
Try adding the command "isdn supp-service name calling" under the Serial interface.
interface Serial0/0/0:23
no ip address
encapsulation hdlc
isdn switch-type primary-ni
isdn incoming-voice voice
isdn supp-service name calling
auto qos voip
no cdp enable
02-25-2009 06:41 PM
Thanks...this did it!
06-09-2008 02:23 PM
Hi,
Please take "debug isdn q931" with "term mon" for an incoming call. Post output here.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide